occurs in any cable segment.
Methods to enable the function
The LFPT function can be enabled by:
Hardware setting:
DIP SW6 is set to ON position
Software setting:
Web management ->
Configuration -> System -> [Link fault pass through]
3.4 Remote TP Status Monitoring Function
Description
The local media converter can monitor the TP port link status of its remote link partner connected on the fiber
cable. The status is displayed on the local LED indicators as follows:
Methods to enable the function
Hardware setting:
DIP SW5 is set to ON position
Software setting:
Web management ->
Configuration -> System -> [Remote TP auto report]
Remote TP Status Display
1.
The status is displayed on local LEDs i.e. TP1G, TP100, TP10, TPFDX when LTP is OFF.
LED
State
Status
LTP
OFF
Remote TP status is valid on the following LEDs
TP1G
ON
Remote TP link in 1000Mbps
OFF
Remote TP link down
TP100
ON
Remote TP link in 100Mbps
OFF
Remote TP link down
TP10
ON
Remote TP link in 10Mbps
OFF
Remote TP link down
-24-
