INSTALL TCS1 FINGERPRINT READER
–
continued
8.
Still holding the reader in place, ensure no gaps exist between the reader and cutout and that no
portion of the blue gasket is visible on the face of the top housing
9.
Still holding the reader in place, flip the top housing to expose underside
10.
Lay the top housing on work surface
11.
Carefully slide fingers away from holding the reader while aligning the four screw holes of the
daughter board frame with the four screw holes embedded in the top housing
12.
Holding the frame in place, screw four Phillips screws to secure the fingerprint reader in place
13.
Check again to ensure no portion of the blue gasket is showing and that the fingerprint reader is
straight and flush with the top housing
14.
Finger press and wiggle the reader to ensure screws have properly secured the installation
