▪
Only use the submersible mixer in the fluid described in the data sheet or
product literature.
▪
Never operate the submersible mixer without fluid.
▪
Observe the minimum fluid levels indicated in the data sheet or product
literature (to prevent overheating, bearing damage, cavitation damage, etc.).
▪
Consult the manufacturer about any use or mode of operation not described in
the data sheet or product literature.
▪
Never exceed the permissible operating limits (temperature, etc.) specified in the
data sheet or product literature.
▪
Observe all safety information and instructions in this manual.
2.4
Personnel qualification and training
All personnel involved must be fully qualified to install, operate, maintain and
inspect the machinery this manual refers to.
The responsibilities, competence and supervision of all personnel involved in
installation, operation, maintenance and inspection must be clearly defined by the
operator.
Deficits in knowledge must be rectified by sufficiently trained specialist personnel
training and instructing the personnel who will carry out the respective tasks. If
required, the operator can commission the manufacturer/supplier to train the
personnel.
Training on the submersible mixer must always be supervised by technical specialist
personnel.
2.5
Consequences and risks caused by non-compliance with these operating
instructions
▪
Non-compliance with these operating instructions will lead to forfeiture of
warranty cover and of any and all rights to claims for damages.
▪
Non-compliance can, for example, have the following consequences:
– Hazards to persons due to electrical, thermal, mechanical and chemical
effects and explosions
– Failure of important product functions
– Failure of prescribed maintenance and servicing practices
– Hazard to the environment due to hazardous substances
2.6
Safety awareness
In addition to the safety information contained in this manual and the intended use,
the following safety regulations shall be complied with:
▪
Accident prevention, health and safety regulations
▪
Explosion protection regulations
▪
Safety regulations for handling hazardous substances
▪
Applicable standards and laws
2.7
Safety information for the operator/user
▪
Provide the personnel with protective equipment and make sure it is used.
▪
Contain leakages so as to avoid any danger to persons and the environment.
Adhere to all relevant laws.
▪
Eliminate all electrical hazards. (In this respect refer to the applicable national
safety regulations and/or regulations issued by the local energy supply
companies.)
2 Safety
8 of 60
Amaprop®
Goodnal STP ST041 Biological Treatment (KSB Amaprop Installation and Operating Manual) Vendor Manual
Q-Pulse Id VM386
Active 29/10/2013
Page 8 of 60
