KS KMPS-1-64 Series, Instruction Manual

Page: 16 / 40

KMPS-1-64 Manual
12/18 KM 8000 Rev. A Page 16 of 40
Copyright © 2018 Kulite Semiconductor Products, Inc.
All Rights Reserved.
SAmplerate
TEmperature arg Sets or returns the temperature sampling rate. See section 4.6 for more
details.
Serial Returns the unit serial number.
SErial MOdules
m
Returns the serial number of module m.
SLope c y
Sets or returns the user gain of channel c. See section 4.10 for more details.
Set in programming mode only.
SPan m A/B
Sets or returns the full scale pressure for the currently selected range of
the module m. If m is omitted returns the ranges for all modules and if A or
B is omitted returns available ranges. See Section 4.4 for more details.
Set in programming mode only.
STream s
Stream pressure for s seconds in format selected by Format command. If
s is omitted the scanner will stream continuously (Ethernet only). If s is 0
then Ethernet scanner will stop streaming.
STream SAmple Sends out a single streaming packet for test purposes.
TEmperature c
Returns the temperature for channel c. If c is omitted returns temperature
for all channels.
TEmperature
CHannel C
Sets or returns the channel used for temperature comparisons in the status
word. See Section 4.3 for more details.
TEmperature
COmpensated
HIgh/LOw M
Sets or returns the high or low compensated temperature of module M.
This value is used for the status word. Set in programming mode only. See
Section 4.3 for more details.
TEmperature
OPerating Returns the maximum operating temperature of the KMPS. This value is
used for the status word. See Section 4.3 for more details.
TYpe c
Returns if a sensor channel if absolute, differential, gauge, or sealed gauge.
If c is omitted returns value for all channels.
UNit x arg
Sets or returns the pressure and temperature units. Valid values for arg
are PSi or Bar for pressure and C or F for temperature. All readings will be
expressed in this unit. See section
Error! Reference source not found.
and Error! Reference source not found. for more details.
USer m x y
Sets or returns one of the user strings to modules m. x is the string number
and y is the string to be saved. See section 4.9 for more details.