Notes:
- Use only cold water. The automatic brewing system has been designed to work only with cold water.
- There are overflowing holes on the back of the water tank to prevent exceeding the capacity of the coffee
maker. If you add too much water, it will leak out from the back of the unit.
- The amount of brewed coffee will be less than the water poured in the watertank since about 10% is
absorbed by the coffee grounds and the filter.
4- Place the carafe with its lid on to the heating plate
(h)
making sure it is fully seated on the heating plate
to activate the pouring mechanism.
CAUTION: To avoid filter basket overflow, the carafe must fit securely into the
coffeemaker with the lid on. If not properly positioned on the heating plate, it could
cause hot water or hot coffee to overflow.
5- Open the coffee maker lid
(b)
, insert the filter holder
(i)
. Make sure it is securely pushed down and
locked. Then insert a standard #4 cone paper filter or the permanent filter
(j)
into the filter holder
(i)
.
Use a fresh paper filter or clean the permanent filter for each carafe of coffee
Fig. 4 and 5
.
6- Add about 2 ounces of ground coffee for 12 cups. Do not exceed the 12 cup level
Fig. 6
.
7- Close the top lid making sure it is securely closed
Fig. 7
.
8- Press the On/Off button
(k)
. The button will illuminate, indicating that your coffee maker has begun the
brewing cycle.
CAUTION: The coffee maker becomes very hot during the brew cycle. Please handle
with care.
Note:
at any time during the brewing cycle, you can turn the coffee maker off by simply pressing the
On/Off button
(k)
. No buttons will be illuminated, indicating that the coffee maker is off.
9- When the brewing cycle is completed, the coffee maker will beep and the On/Off button
(k) will blink. This indicates that the keep warm cycle has started.
Notes:
When the brewing cycle is finished, there will still be hot liquid in the filter basket. Wait a few
minutes for the rest of the liquid to drip through into the carafe before removing the basket.
- The keep warm function will operate up to two hours. During the keep warm cycle, the On/Off button
(k)
will keep flashing and the LCD display will count up the time since brewing completed. At any time you
can stop the keep warm cycle just by pressing the On/Off button
(k)
. When the keep warm cycle is done
the LED will switch off and the LCD will display the clock again.
10- Open the top lid and carefully remove the filter holder by grasping the tab on each side of the filter
holder, and lifting straight up from the filter holder. Discard the used coffee filter (if using a paper filter)
and grounds
Fig. 8 and 9
.
Note:
- If two or more pots of coffee are to be made it is recommended to let the coffee maker cool down for 10
minutes between each brewed pot.
Auto Shut-Off
As a convenience, your coffee maker has been designed with an Auto Shut-Off feature. When the brewing
cycle is completed, the coffee maker will shut off automatically after 2 hours.
English
8
KR_CAFETIERE_KM730_NC00116597_Mise en page 1 06/11/12 12:00 Page8
