Krups Grind & Brew KM8328, Manual

Page: 16 / 140

16
COFFEE PREPARATION WITH COFFEE BEANS
1. Fill coffee bean box with coffee beans. (fig.1)
Beware! Do not use too oily beans which may damage your appliance.
2. Open the filter holder.
3. Insert the paper filter.
(fig.4)
4. Close the filter holder.
(fig.6.1)
5. Place coffee carafe on the keep warm plate. (fig.6.2)
6. Set desired grinding fineness using Grind adjust knob (F). (fig.3) Grind your coffee from
coarse to fine by using Grind adjust knob (F) from big point to small point.
7. Set the desired number of cups using Number of cups button(H3). Number of cups (G5)
displays the number chosen.
8. Set coffee strength using Coffee strength button (H4). Coffee strength indicator (G2)
displays the strength chosen.
9. Press On/Off button (H1) to start the coffee preparation cycle:
– On/Off indicator (H2) flashes.
– Operation indicator (G4) flashes.
– Grinder runs, then hot water goes across the ground coffee freshly prepared by the
grinder.
10. When the coffee cycle is finished:
– The appliance beeps 3 times when it is switched off.
– On/Off indicator (H2) changes from “flashes” to “lights up”.
– Operation indicator (G4) stops and disappears.
– The appliance enters 30 minutes keep warm.
– On/Off indicator (H2) lights off after keep warm.
COFFEE PREPARATION WITH PRE-GROUND COFFEE
1. Open the filter holder.
2. Insert the paper filter.
3. Put desired quantity of coffee powder into the filter.
(fig.5)
4. Close the filter holder.
5. Fill water tank with desired quantity of water.
Beware! Do not put coffee powder in the bean container, only in the paper filter,
or it may damage your appliance.
6. Place coffee carafe on the keep warm plate.
7. Press the Ground coffee selection button (H8). Ground coffee indicator (G3) appears on
the display.
8. Press On/Off button (H1) button to start the coffee preparation cycle:
– On/Off indicator (H2) flashes.
– Operation indicator (G4) flashes.
– Ground coffee indicator (G3) lights up.
– Hot water flows through the ground coffee into the carafe.
9. When the coffee cycle is finished:
– On/Off indicator (H2) changes from “flashes” to “lights up”.
– Operation indicator (G4) stops and disappears.
– Ground coffee indicator (G3) disappears.
– Machine enters 30 minutes keep warm.
– On/Off indicator (H2) switches off after keep warm.