Krups Espresso Automatic EA89 Series, Quick Start Manual

Page: 33 / 341

29
EN
!
Important
: If you unplug your machine during the cleaning cycle, or if there is a power failure, the cleaning program
will continue from the current phase when the power is returned. It is not possible to postpone this
process. This is essential to ensure that the water circuit has been correctly rinsed. In this case, a new
cleaning tablet may be necessary. Complete the full cleaning program in order to remove all of the
cleaning product which is harmful to health.
Cleaning the “One Touch Cappuccino” block
To complete a cleaning program, you will require two containers (minimum 0.6 L) and KRUPS cleaning liquid.
You can start the cleaning cycle by pressing button
.
Then selecting “Maintenance”

“Milk Cleaning”. Follow the instructions on the screen.
Dismantling the “One Touch Cappuccino” block
In addition to rinsing, it is necessary to clean the different elements of the block every time after using. To dismantle
the block, follow the following instructions:
Remove the milk tube,
Fig. 21
.
Remove the front lid of the coffee milk nozzles. Slide it downwards and pull it towards you. Fig. 22 .
Remove the “One Touch Cappuccino” block by pulling the upper part of the block
Fig. 23
.
Completely dismantle the block. Fig. 24 .
Remove the milk tube connector
Fig. 25
.
Clean all of the dismantled parts (block, connector and milk tube) with soapy water. Then rinse them in hot water. Fig.
26
.
Once the elements are clean and dry, assemble the block and return them to their original position. Fig. 27 .
Replace the font lid of the block.
Fig. 28
. Replace the connector in the milk tube
Fig 29
(opposite side of the bevelled
side) and plug in the block. Fig. 30 .
Automatic descaling program of the steam circuit
Warning
: if your appliance is fitted with our Claris - Aqua Filter System cartridge, remove the cartridge before
descaling.
A message on the screen will indicate when a descaling program needs to be run for the appliance. The frequency of
this program depends on the quality of the water used and on whether a Claris Aqua Filter System filter is used or not
(the harder the water, the more often the appliance has to be descaled).
!
Important
: You are not obliged to carry out this program immediately the appliance requests it, but it must be
carried out reasonably soon afterwards. If descaling is postponed, the alert message will continue to
be displayed until the process is completed.
When the descaling alert level is reached and displayed, press to run the descaling program. To delay it, press
.
Once the procedure has been launched, follow the instructions provided on the screen. It is also possible to run a
descaling cycle via the “Maintenance” menu
 “Descaling”.
To carry out a descaling program, you will require a container with a capacity of at least 0.6 L which should be placed
beneath the One Touch Cappuccino block and a KRUPS descaling sachet (40 g).
Fig. 34b
Fill the water tank up to the CALC mark then pour in the contents of one sachet of descaler.
The descaling program comprises three phases: a descaling cycle and two rinsing cycles. The program lasts
approximately 20 minutes.
!
Important
: If there is a power failure or if you unplug your machine, the cycle will continue from the current phase
when the power is returned. It will not be possible to cancel this operation. Complete the full cycle in
order to remove all of the descaling product which is harmful to health.