6.2 With the steam nozzle (depending on model)
Note:
After the steam function has been used, the nozzle will be hot, and we recommend that you
wait for a few moments before handling it.
Check that the steam nozzle is correctly fitted.
Fig. 22
Pour the milk into your milk jug. Only half fill it. Immerse the nozzle in the milk. Immerse the steam
nozzle in the milk.
Fig. 23
Press the “steam”
key
Fig. 15
and follow the instructions on the screen.
When the nozzle is hot, handle it only with the plastic part.
Fig. 24
Again press the “steam” key
Fig. 15
to stop the cycle.
Be careful, because the cycle does not stop immediately.
To achieve a good result:
To achieve a good result:
Stage 1: While holding the milk container, immerse the steam spout into the milk (about 2 cm) and wait
for it to start frothing.
Stage 2: Raise the container slightly (about 1 cm).
Never immerse the metal tube completely.
Stage 3: Lower the container gradually as the foam increases.
To remove any remaining milk from the steam nozzle, place a container under the nozzle and press the
“hot water”
key.
Let the steam escape for at least 10 seconds and then again press the “hot water” key
to stop the
process.
You can remove the steam nozzle for thorough cleaning
Fig. 25
. Wash it using a brush with water and
a little non-abrasive washing up liquid. Rinse and dry it
Fig. 25-26
.Before re-fitting, make certain that
the air inlet holes are not clogged by milk residues. Clean out the holes with a needle if necessary
Fig.
27
.
Note:
To interrupt the steam function, just press any key. If the nozzle is blocked, clean it out with
a fine needle.
7.1 Emptying the coffee grounds collector, the coffee cleaning tray and
the drip tray
After 12 coffees, the machine will ask you to empty the coffee grounds collector and to clean the coffee
drawer. Failure to perform these operations correctly can damage your machine.
Wait at least for 8 seconds before refitting the coffee drawer and the coffee grounds collector, and
follow the instructions on the screen.
The drip tray collects the used water and the coffee grounds collector collects the used coffee grounds.
The coffee drawer allows you to remove any coffee grounds below the
percolation chamber.
If the above message appears, remove, empty and clean the drip tray.
1. Remove, empty and clean the coffee grounds collector.
Fig. 28
2. Remove the cleaning tray.
Fig. 28
First put the cleaning tray back then the coffee grounds collector.
The drip tray is equipped with a float to indicate when it needs emptying.
Fig. 29
!
7. MAINTAINING YOUR APPLIANCE
!
29
EN
KR_ESPRESSO_EA83_EO_EA83_NEW CHARTE 30/05/13 11:28 Page29
