38
Owner’s manual
EN
SET THE ALARM TIMER
This unit can be used as an alarm clock. You can select DISC, USB or TUNER
as alarm source.
Note:
Ensure that you have set the clock correctly.
1. In standby mode, press and hold the
TIMER/SLEEP
button until [TIMER
SET] (set timer) scrolls on the display.
2. Press
VOLUME UP/DOWN
/ button on the remote control to select source.
3. Press
TIMER/SLEEP
button, the hour indicator will blink.
4. Set the hour with the
VOLUME UP/DOWN
/ buttons on the remote control.
5. Press
TIMER/SLEEP
button, the minute indicator will blink.
6. Repeat above steps 4-5 to set the minute.
7. Repeat above steps 4-5 to set the alarm volume.
Activate / deactivate alarm timer
In the standby mode, press
TIMER/SLEEP
button repeatedly.
• If timer is activated, the icon is displayed.
• If timer is deactivated, the icon disappears.
Note:
• To exit timer setting mode without storing, press the
STOP
button.
• If no button is pressed in 90 seconds, the unit exits clock setting mode automatically.
• If DISC/USB source is selected and the audio cannot be played, TUNER is
activated automatically.
• To keep the disc clean, please don’t touch the disc’s surface when you are
holding it. You should hold the edge.
• If the disc is dirty, it will affect the sound quality. Please use the clean and soft
cloth to wipe the disc from inside to outside. Don’t wipe the disc in circular motion.
• Don’t stick paper on the disc.
•
After you have finished with the disc, please place it back in its original case.
To avoid warping or damage, do not stack discs.
•
Don’t play the disc which has flaw or deformation, in case of damaging this player.
• Clean your discs using only a soft dry cloth. Do not use any chemicals such as
benzine, thinner, antistatic or record sprays as these can damage the disc surface.
PROTECT THE DISC
