Kruger&Matz DJ-002, Owner'S Manual, Page: 38 / 88

38
Owner’s manual
English
1. Adjust the definite level of the output signal at the master outputs with the
controls MASTER CONTROL and MASTER LEVEL.
2. Adjust the desired signal level for the output BOOTH with the control
BOOTH VOLUME.
3. The recording signal at the recording output REC is taken off ahead of the
output controls, i.e. it is not affected by the controls MASTER CONTROL,
MASTER LEVEL and BOOTH VOLUME.
4. CROSSFADING BETWEEN THE DECKS
1. The crossfader allows crossfading between both decks:
• crossfader moved to the left: fade-in of Deck A and fade-out of Deck B
• crossfader moved to the right: fade-in of Deck B and fade-out of Deck A
• for hearing the signals of the two decks at the same level, set the crossfader
to mid-position
2. The characteristic of the crossfader can be adjusted with the control
X-FADER CURVE:
• left position: smooth crossfading (gradual transition) e.g. for long mixes
• right position: sharp crossfading (abrupt transition) e.g. for scratching and
cutting.
CAUTION! Do not use the control X·FADER CURVE while a signal is present
as this may cause a sudden change in volume.
5. ANNOUNCEMENTS VIA THE DJ MICROPHONE
Announcements via the DJ microphone are directly mixed to the master signal.
Use the control MIC LEVEL to adjust the desired volume.
6. PREFADER LISTENING TO THE CHANNELS (PFL)
The cue function allows monitoring each of the decks via headphones even
if the corresponding channel is faded out. Thus, it is possible, e.g. play the
beginning of a title, to set a cue point, or to adjust a continuous loop without
the audience listening in. Alternatively it is possible to monitor the current music
program ahead of the controls MASTER CONTROL and BOOTH VOLUME.
1. ZUse the cue mode selector (41) knob to select the cue mode for the
headphones.