Krone EasyCut F 320, Original Operating Instructions

Page: 34 / 86

6 Initial Operation
6.1 Checklist for initial operation
34 Original Operating Instructions 150000802_00_en
6 Initial Operation
WARNING
Risk of accident or damage to the machine due to incorrect initial operation
When a machine is assembled by unqualified personnel, it may happen that it is has defects
due to lack of knowledge. Thus there is a risk of serious injuries or death.
„
The initial operation must only be performed by an authorized specialist.
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
„
To avoid accidents, the relevant safety instructions must be read and observed,
refer to
page 12
.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
„
The safety routines must be read and observed to avoid accidents,
refer to page 23
.
6.1 Checklist for initial operation
ü
The machine is mounted according to assembly instructions of the machine.
ü
All screws and nuts are checked for firm seating and tightened with the prescribed
tightening torque,
refer to page 55
.
ü
The safety devices are mounted and checked for completeness and damage.
ü
The machine is lubricated completely,
refer to page 75
.
ü
The oil level was checked on all gearboxes,
refer to page 61
.
ü
The hydraulic system is checked for leaks.
ü
The tractor corresponds to the machine requirements,
refer to page 32
.
ü
The axle loads, the minimum counterweight and the total weight are checked.
ü
The universal shaft length is checked and adapted,
refer to page 37
.
ü
The blades are inserted,
refer to page 67
.
ü
The hydraulic system is vented.