RUNNING GEAR OPERATION
Operating instructions • Box Carrier • 505410619-02 • 05/2021
27
► Raise the trailer to the desired ramp
height using the air suspension
"5.10 Air suspension", pg. 42)
► Lift the hand crank from the bracket.
► Engage the hand crank on the crank
drive shaft until it locks into place.
► Switch on high speed by pulling out
the hand crank
speed and high speed of the rear brace",
pg. 26)
.
► Wind down the landing legs until they
touch the ground.
► Switch on load speed by pushing in
the hand crank
speed and high speed of the rear brace",
pg. 26)
.
► Use the hand crank to wind to the de-
sired support height.
ð
The rear braces are extended.
► Adjust the front landing leg winch
"5.2 Landing leg winches", pg. 24)
.
► Align the trailer level in the longitudinal
and transverse directions. Do not fully
unload the wheels while doing so.
► Lower the trailer with the air suspen-
(see "5.10 Air suspension", pg. 42)
ü
The rear braces have been placed in
the support position
ü
The trailer is supported at the rear only
by the rear braces.
Putting the rear braces in the driving
position
► Check the parking brake and apply if
.
► Take the hand crank from the bracket.
► Engage the hand crank on the crank
drive shaft until it locks into place.
► Set to load speed by pushing in the
and high speed of the rear brace", pg. 26)
► Wind up the landing leg until it is un-
loaded.
► Set to high speed by pulling out the
hand crank
and high speed of the rear brace", pg. 26)
► Wind up the landing leg up to the stop.
► Secure the hand crank in the bracket.
ü
The rear braces have been put in driv-
ing position and the crank is secured.
5.3.2
Rear braces without crank
mechanism
Putting the rear braces in the support
position
1
4
2
3
Fig. 5-4:
Folding down the rear brace
1
Bolt for the height lock
2
Spring cotter pin for the folding mech-
anism
3
Retainer handle
4
Bolt for the folding mechanism
► Raise the trailer to the desired ramp
height using the air suspension
"5.10 Air suspension", pg. 42)
.
► Remove the spring cotter pin for the
folding mechanism.
► Support the rear brace by its handle
and remove the bolt for the folding
mechanism.
► Fold down the rear brace.
► Reinsert the bolt for the folding mech-
anism.