fuel tank and U.A.T.
If you are using a turbine
with 140N or lower, the
recommended fuel tank from
krill is ideal. And offers a
complete unit for fuel, smoke
and air trap combined into a
nice single unit that fits
great in the space available.
however if your intending to
install a 180N or higher
turbine we recommend using
a single large fuel cell as seen
on the right.by CM jets.
To install the tank, all that’s needed is to use the plywood tank mounts supplied. Screw the tank
in with 4mm claw nuts and bolts provided making sure they are centred and have an equal gap
either side. Remove mounting plates from the tank and glue and screw with hysol. The
front
fixing on to the rear face of the centre former, under the turbine mounting rails as shown below.
Now screw front mounting to the tank. Slide the rear plate
under the tanks fixing also under
the turbine mounting formers and
screw together. Now screw the
plate to the former. When this is
done you can remover tank and rear
plate for gluing and then reinstall using
the screws you fixed it in with earlier.
vent tubes run down and through the formers and into one placed either side next to the
intakes. 16.
