3. Repeat for the other side of the knife in the right hand Fine Grind Knife Slot.
Scissors sharpening
1. With the sharpener switched on, insert one of the
scissor blades as far forward as it will go into the outer
edge of the Scissor Slot.
2. In a single motion, move the scissor blade up and left
into the slot, until you feel the blade is in good contact
with the spinning grinding wheel, then steadily pull the
entire length of the scissor blade through the slot to the
rear of the sharpener, maintaining a constant light
pressure.
3. Repeat steps 1 and 2 of Scissor Sharpening two more
times.
4. Repeat steps 1 to 3 of Scissor Sharpening for the other scissor blade.
5. Set the ON/OFF Switch to the OFF position, to switch the sharpener off.
Screwdriver restoring
1. With the sharpener switched on, insert the point of the
damaged screwdriver blade into the Screwdriver Slot,
until it makes contact with the spinning grinding wheel.
Hold it in position briefly, then withdraw the screwdriver.
-‐ The grinding action is very effective, so do not use undue
pressure or apply for longer than a second or two at a
time. Use only with flat-‐bladed screwdrivers.
2. Examine the screwdriver to determine if the damage
has been repaired and repeat step 1 as necessary, turning
the screwdriver through 180° each time.
3. Set the ON/OFF Switch to the OFF position, to switch
the sharpener off.
3. MAINTENANCE & CLEANING
Before using for the first time,
as you unwrap the product, make sure your remove all packaging materials.
Wipe all the parts with a damp towel.
Do not add water when sharpening a knife, a scissor or a screwdriver, otherwise it will cause risk of electric
shock.
Knives should be clean and dry before being sharpened and should be wiped clean after sharpening. Take
care when wiping knives as they become extremely sharp.
