KRESS ANGLE GRINDER, Original Instructions Manual

Page: 23 / 276

Device description English 23
WS-EN / 0909
EN
3. Device description
For help, please use the enclosed illustrations
showing the device. Open these illustrations while
reading the operating instructions.
Operating elements
I Spindle stop button
II On/off switch
III Stop / unlocking switch (Option)
IV Adjuster for speed selection
V Clamping screw or clamping lever (Option)
VI Interlock button mains cable module (Option)
VII Handle unlocking button (Option)
Device components
1 Additional handle
2 Machine head
3 Motor housing
4 Bow-shaped handle (Option)
5 Protection guard for grinding
6 Protection guard for cutting (Accessory)
7 Auxiliary handle collar
8 Grinder spindle
9 Adjustment screw (Option)
10 Mains cable module / fixed supply
11 Clamping flange
12 Clamping nut
13 Quick-clamping nut Fixtec (Accessory)
14 Face spanner
15 Grinding disc (Accessory)
16 Cutting disc (Accessory)
17 Cup-shaped wire brush (Accessory)
18 Backing pad with sanding disc (Accessory)
Scope of supply
See packaging
The machine is intended for cutting, roughing, and
brushing metal and stone materials without using
water.
For cutting metal, a special protection guard for
cutting (accessory) must be used.
With approved sanding tools, the machine can be
used for sanding with sanding discs.
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
Read all the warnings and instruc-
tions before using the equipment.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Specified Conditions of Use
Requirements for the user
Technical data
Mains voltage in V / Frequency in Hz
Input power in Watts (W)
Output power in Watts (W)
Noise levels
L
pA
= A-rated noise level
L
wA
= A-rated noise output level
K = Measurement uncertainty value
The noise level can exceed 85 dB(A)
during operation.
Wear hearing protection!
Triaxial vibration emission level
determined in accordance with EN
60745.
K = Measurement uncertainty value
Roughing (surface grinding):
Vibration emission level a
h
Sanding with sanding discs:
Vibration emission level a
h
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
BA_WS_EN.fm Seite 23 Donnerstag, 15. Oktober 2009 3:27 15