KRESS ANGLE GRINDER, Original Instructions Manual

Page: 27 / 276

Operation English 27
WS-EN / 0909
EN
Locking the grinder spindle
The grinder spindle must be locked in position in
order to change tools.
To lock the grinder spindle, press spindle
stop button
I
and hold it pressed.
If it is not possible to depress the spindle stop but-
ton all the way, rotate the grinder spindle clock-
wise until it engages.
Mounting the Grinding Tool
Clean the grinder spindle
8
and all parts to be
mounted.
Insert tool
15/16
in the correct position. The
correct sequence for mounting is shown in
the illustrated instructions "Mounting the
grinding tools."
Screw clamping nut
12
onto grinder spindle
8
in the correct position.
Press spindle stop button
I
and hold it
pressed.
Tighten clamping nut
12
with face spanner
14
.
Removing grinding tools
Press spindle stop button
I
and hold it
pressed.
Release and remove clamping nut
12
from
spindle
8
by turning the nut anti-clockwise us-
ing face spanner
14
.
Remove tools and clamping flange
11
from
spindle
8
.
Mounting a cup-shaped wire brush
Clean grinder spindle
8
.
Screw cup-shaped wire brush
17
directly onto
grinder spindle
8
without using clamping
flange
11
and clamping nut
12
.
Press spindle stop button
I
and hold it
pressed.
Tighten cup-shaped wire brush
17
with an
open-ended wrench.
Removing the cup-shaped wire brush
Press spindle stop button
I
and hold it
pressed.
Release cup-shaped wire brush
17
with an
open-ended wrench.
Do not strain the machine so heavily that it comes
to a standstill.
Mounting the Grinding Tools
Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures
prevent accidental start of the power
tool.
Wear safety gloves for
tool chang-
ing
.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert
are sharp.
-WARNING-
Observe the tool-specific information in Chapter
5.
-NOTE-
Actuate the spindle lock button only when the
grinder spindle is at a standstill. Otherwise, the
machine may become damaged.
Do not use a damaged accessory.
They may break, thus increasing the
risk of injury.
-NOTE-
Before switching the machine on after mounting
the grinding tool, check that the grinding tool is
correctly mounted and can rotate freely. Make
sure that the grinding tool does not brush against
the protective cover or other parts.
Operating tips
Clamp the workpiece if it does not
remain stationary due to its own
weight.
Grinding and cutting discs become
very hot while working; do not touch
until they have cooled.
Wear protective glasses and hearing
protection.
BA_WS_EN.fm Seite 27 Donnerstag, 15. Oktober 2009 3:27 15