Kress Robotik KR101E, Owner'S Manual

Page: 15 / 204

15
EN
Battery charge error.
1) Battery’s temperature is too high (more than 550C) when charging.
Place the charging base in a shady area or wait until the temperature
has cooled down.
2) Battery’s temperature is too low. The outside temperature doesn’t
allow your
Mission
TM
NANO to work. It’s time to recover it for winter
time.
3) Poor connection: check the connection between the contact pins
located on the charging base and the charging strip and that the
charging base is on a perfect flat ground.
4) Power supply is broken: please contact Customer Services.
Error find home
timeout.
1) Charging base is badly placed (not on a flat ground),
Mission
TM
NANO doesn’t find pins and doesn’t stop. Check the base.
2) Mission
TM
NANO runs out of battery before reaching the charging
base. The extended boundary wire should not exceed 350 meters.
With the ‘Lock
Function’ enabled, if
your
Mission
TM
NANO
does not receive
a signal from your
Wi-Fi router for 3
days, then it gets
locked as a security
measure.
This could be
because your
router lost its power
or because you
changed your Wi-Fi
router or network
provider.
Please reconnect Mission
TM
NANO to the Wi-Fi network it has been
originally paired with.
If this is not possible, contact Customer Service.
Module software
update failure
occurs. Please check that the module is correctly connected. Check that the
file copied in the USB stick is not damaged.
Turn power off, then turn it on and try the software update again.
Software update
failure occurs.
Please try the software update again or contact Customer Service.
NOTES
• Before turning power on, always check Mission
TM
NANO is inside its working area.
• If for any reason—i.e. a party, children playing...—you want to park your Mission
TM
NANO in the charging
base: press HOME then OK. Mission
TM
NANO will go to its base and stay there. Please note Mission
TM
NANO
will now wait until the next scheduled mowing session. If you want to re-start it at anytime, press START
then OK to start your
Mission
TM
NANO .
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary
wire so please refer to the installation instructions and check your set up is correct with its help.
• If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which
is not provided with the charging base: when Mission
TM
NANO runs out of charge, take it manually to the
charging base.
• If Mission
TM
NANO runs abnormally once in a while, please reset it by turning it off and removing the battery
for 30 seconds, then restart it. If the problem cannot be solved, please contact our Customer Service for
help.