Rev. Date: 12/14/10
Page 24
MODEL #5200-P
F. Check belts, adjust /replace as required and check
for missing keys under drive pulleys.
G. Fiber hose plugged. Make sure the air bypass
valve is completely closed, then switch machine
to blower only to blow out the hose. If problems
still occur, try hitting the hose where it is plugged
to release the material.
H. If the airlock seals and/or airlock components are
worn or damaged, replace all the parts as needed.
5.) No material flow - clutch is operating
A. Check material level in main hopper.
B. If the material slide gate is closed or adjusted in
too far for material feed rate, open the slidegate.
C. Check the belts coming from the main drive shaft
pulley to the reducer shaft drive pulley and blower
shaft drive pulley. Adjust or replace belts as
required. Check for missing keys under the drive
pulleys.
D. Check chains, adjust or replace as required.
Check for missing keys under drive sprockets.
E. Fiber hose plugged. Make sure the air bypass
valve is completely closed, then switch machine
to blower only to blow out the hose. If problems
still occur, try hitting the hose where it is plugged
to release the material.
SPARE PARTS LIST
The following is a recommended spare parts list. To keep your machine up and running, these are
the parts we suggest you keep on hand for your Model #5200 Krendl Machine.
PART
DESCRIPTION
QUANTITY
NUMBER
REQUIRED
250503-8
AGITATOR BEARINGS
6
8036-2
SHREDDER BEARINGS
4
8065-2
AIRLOCK BEARINGS
2
1032
JACK SHAFT BEARINGS
2
5200-72
V-BELT PTO SHAFT TO GENERATOR
1
5200-38
V-BELT PTO SHAFT TO JACKSHAFT
1
5200-37
V-BELT JACKSHAFT TO BLOWER
1
5200-9M
AIRLOCK SEALS
6
150526
#50 MASTER LINK
4
Relief Valve
Illustration 15
Check Valve