Rev. Date: 12/14/10
Page 11
MODEL #5200-P
INSTALLATION
MACHINE DRIVE AND TRUCK SPECIFICATIONS:
Your Model #5200-P Krendl Machine can be mounted in any truck and chassis configuration. We
recommend a minimum chassis rating of 26,000 GVWR. We also recommend a minimum 22 feet van
body. The body should have a full width rear door. The Krendl Model #5200-P Machine can be mounted
anywhere in the truck body. The factory recommended positions are shown in Illustration 3.
TOOLS NEEDED:
CUSTOMER SUPPLIED ITEMS:
1/2” Heavy Duty Drill
1/2” Bolts, washers, locknuts for fastening machine
Drill Bits: 9/16” for bolts
Fork Lift (means to lift the machine)
Pry Bars
Basic Wrenches
5” hole saw & 2” hole saw
INSTALLATION INSTRUCTIONS:
1) Place the machine in either of the two locations so that the machine will not be in the way of the
truck’s doors and you are still able to open the hood of the machine.
2) Using illustration 3 as a reference, check under the truck body that the opening will not interfere
with any truck components underneath. If there is any interference with any of the truck parts,
then you will need to adjust the position of the machine to clear the obstruction. The holes for the
blower inlet and machine hold down do not have much room for adjustment. However, the holes
for the hydraulic lines do have room for slight adjustments.
Illustration 3
3) Remove the machine after the holes are located.