Install the Bench and Pegboard
To mount the bench. Slide it into position on the Small Boxes. Attach the Hinge Plate by driving 1 1/4" coarse-thread pocket
hole screws into the Small Box Tops.
If you want to add a Pegboard panel, cut it to size, as shown in the cutting diagram. Also cut a Pegboard Cleat from a 1x2
board. Measure down 16 3/4" from the underside of the Large Boxes, and then secure the cleat to the wall. It doesn’t need
the heavy-duty anchoring that the Ledgers require. Just drive a couple screws into the studs or into wall anchors. Then
attach the Pegboard to the cleat and the Upper Ledger with 3/4" screws.
You can leave your storage unit bare but adding finish or paint will protect it and keep it looking good. We just added a coat
of wipe-on a polyurethane. Finish the Shelves, as well, and then put them in place on shelf pins. Then load up your storage
and work center!
12
Page 12 of 13
Summary of Contents for Garage Storage and Work Center
Page 4: ...Page 4 of 13...
Page 5: ...Page 5 of 13...
