KRAUSMANN U63020-00B, Operation Manual, Page: 21 / 24

21
KRAUSMANN POWER TOOLS U63020-00B
English | EN
fig 5
fig 6
The ideal for plunge cutting directly into surfaces
that can not be cut from an edge, such as walls or
floors. Do not plunge cut into metal surfaces.
Begin cutting at a slow speed, gradually increasing
speed as you cut. When cutting into metals or hard
materials that can not be cut from an edge, drill
a starting hole larger than the widest part of the
blade.
Plunge Cutting
Cutting Metals
Insert the blade into the tool with the teeth
facing down. Hold the tool resting the edge of
the shoe on the workpiece (fig 5).
W ith the blade just above the workpiece,
start the tool. Using the edge of the shoe as
a pivot, lower the blade into the workpiece.
As the blade starts cutting, raise the handle
of the tool slowly until the shoe rests firmly
on the workpiece (fig 6). Then guide the tool
along your cutting line to acquire the desired
cut.
5. Maintenance
Correct and regular cleaning will improve the safe-
ty and extend the lifespan of the device.
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with
compressed dry air or with a soft cloth moistened
with soapy water. Always wear safety goggles
when cleaning tools with compressed air.
Certain cleaning agents and solvents damage
plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
S tore the tool, operating instructions and where
necessary the accessories in the original packag-
ing. In this way you will always have all the informa-
tion and parts ready to hand.
Wear ear defenders
Wear safety goggles
WARNING:
T urn the device off, disconnect it from the mains and wait
until it cools down before cleaning or maintenance to
avoid electric shock or burn.
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for amateur use covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For
possible faults during the warranty period, you
should address your issue to the retail shop from
which the purchase was made.
6. Warranty
Terms of warranty
The warranty is valid only when: