18
2100
KRAUSMANN POWER TOOLS
English |
EN
WARNING:
T
urn the device off, disconnect it from the mains and wait
until it cools down before cleaning or maintenance to
avoid electric shock or burn.
Wear ear defenders
Wear safety goggles
The tool has been used properly and for the
purpose for which it was purchased.
The tool presents a problem that is due to
faulty material and manufacturing.
I
ncapability of the tool to perform according
to the technical specs provided.
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for
amateur use
covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For pos-
sible faults during the warranty period, you should
address your issue to the retail shop from which
the purchase was made.
6. Warranty
Terms of warranty
The warranty is valid only when:
5m
A
B
X1
X2
fig 7
5. Maintenance
Correct and regular cleaning will improve the safe-
ty and extend the lifespan of the device.
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with
compressed dry air or with a soft cloth moistened
with soapy water.
Always wear safety goggles
when cleaning tools with compressed air.
Certain cleaning agents and solvents damage
plastic parts.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
The brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the motor,
we recommend every two to six months the
brushes be examined.
S
tore the tool, operating instructions and where
necessary the accessories in the original packag-
ing. In this way you will always have all the informa-
tion and parts ready to hand.
5m
A
B
X1
X3
X2
180º
fig 8
Turn the tool 180°, let the vertical area go through
point
Χ1
and make a self levelling with the cross
point
Χ3
. Calculate the distance between
Χ1
and
Χ3
(fig 8).
The formula to calculate the acceptance deviation
is:
d
max= 2 × distance between A & B × 0.2mm/m
If the distance is ≥ 3mm, then the accuracy of the
instrument is out of function and needs to be
repaired.