Trouble - Shooting
If you have followed the instructions carefully and your faucet still does not work
properly, take the following corrective steps:
P R O B L E M
C A U S E
A C T I O N
Leakage under the
handle
Bonnet nut (12) has
come loose
Remove the index (14.3).
Loosen set screw (14.2) with
hex wrench (14). Remove
the handle (14.1). Unscrew
cap (13) (by hand only).
Tighten bonnet nut
(12) with an adjustable
wrench
The aerator has an
irregular or reduced
water flow
The aerator is dirty or
mis-fitted
Remove the aerator and
check for debris.
Ensure that the rubber
washer is properly
installed.
The water pressure
is low.
The connector
underneath the deck is
clogged with debris
The aerator is clogged
Turn off the water supply
and disconnect the
connector
/
aerator.
Unscrew the connector /
aerator and clean under
running water.
Screw the connector /
aerator back.
Test water flow. If water
pressure is still low then
replace the connnector /
aerator.
Care & Maintenance
*To keep the product clean & shining, follow the steps below:
1.
Rinse with clean water & dry with a soft cloth
2.
Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3.
Do not use cloth with a coarse surface
4.
Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
10
9
11
12
13
Hexagon Nut
Hot
Water
Cold
Water
1
11
Close
Open
Left
Hot Water
Push
25˚
90˚
12
13
10
