Kratki NADIA 14/P/BS/G, General Manual And Warranty Card

Page: 3 / 32

3
Thank you for the confidence shown to us by purchasing the fireplace insert manufactured by
kratki.pl. Before fitting and using the insert, please read these instructions.
General information
NOTE! To avoid the risk of fire, the device must be installed in accordance with the current standards
and the technical regulations referred to in the manual. Its installation must be done by a profession-
al or a qualified person. This device complies with the EN 13229 and is CE certified.
Always obey the laws of the place where the device is installed. First, make sure that the flue is
suitable.
The device must be installed in accordance with the current standards of the construction law.
The insert must be set at a safe distance from any flammable products. It may be necessary to protect
the walls and the materials around. The unit must stand on a solid, non-combustible base. The flue
must be tight and its walls smooth, before connecting, it should be cleaned of soot and contamina-
tion. The connection between the flue and the insert must be tight and made of non-combustible
materials protected against oxidation (an enamelled or a steel pipe).
If the flue produces weak draught, consider laying new pipes. It is also important for the flue not to
produce excessive draught, you must then install a draught stabilizer in the flue. Alternatively, there
are also special flue endings regulating draught. Control of the flue draught should be carried out by
a chimney specialist, any modifications can be made by an authorized company, in order to have the
requirements of PN-89/b-10425 fulfilled.
The first ignition WARNING!
At the first ignitions, the device should function at slow run, to enable the parts’ normal dilation.
Door handles and other handles are warm during operation of the insert. During operation, you
should use protective gloves. Acrid smoke and smell coming from the insert during the first ignition
are not a cause for concern - this phenomenon is caused by paint burning (polymerization or harden-
ing of the paint) in the fireplace insert.
Before the first ignition, remove all stickers or pieces of equipment that can be found in the combus-
tion chamber. During the first firing in the insert, maintain the minimum temperature and slightly
open the door (approx. 12 cm) for the sealing material to be connected with the varnish. All materials
must slowly adapt to high temperatures.
During the first few usages, each insert emits an unpleasant smell, caused by paint burning. This
smell will disappear after a short time. During the smell emission, always ventilate the room in which
the insert is.
Important: before lighting a large fire, light a small one be two or three times. This will enable the
insert structure to be firmed and the paint to be hardened.
NADIA/14/L/BS/G NADIA/14/P/BS/G NADIA/14/PW/W