Connecting the VS-88SDI
9
9
6
Connecting the VS-88SDI
The
VS-88SDI
can switch one of the eight SDI inputs to any or all of the
eight SDI outputs, as the example in
Figure 2
shows.
To connect the
VS-88SDI
, do the following
1
1. Connect up to eight SDI sources to the SDI INPUT BNC connectors (for
example, an SDI camera to INPUT 1 and an SDI player to INPUT 8).
:
2. Connect the SDI OUTPUT BNC connectors to up to eight SDI acceptors
(for example, OUTPUT 1 to a non-linear editor, and OUTPUT 8 to an SDI
display).
3. Set the DIP-switches (see section
6.1.2
).
4. Optionally
2
•
A genlock source to the GENLOCK BNC connector
, connect:
•
The LOOP
BNC connector to the GENLOCK connector of the
next unit in the line, and release the TERM
button for looping
3
5. Connect a PC and/or controller (if required), to the:
•
RS-232 port (see section
6.1
), and/or
•
RS-485 port (see section
6.2
), and/or
•
ETHERNET connector (see section
6.3
)
6. Connect the power cord
4
1 Switch OFF the power on each device before connecting it to your VS-88SDI. After connecting your VS-88SDI, switch on
its power and then switch on the power on each device
.
2 Not illustrated in
Figure 2
3 Pushed in terminates the input. Release when the input extends to another unit
4 We recommend that you use only the power cord that is supplied with this machine
