Kramer VS-88DT, User Manual, Page: 36 / 62

Kramer Electronics Ltd.
VS-88DT
– Kramer Protocol
34
Chaining Commands
Multiple commands can be chained in the same string. Each command is delimited by a pipe
character (“|”). When chaining commands, enter the
message starting character and the
message closing character only once, at the beginning of the string and at the end.
Commands in the string do not execute until the closing character is entered. A separate
response is sent for every command in the chain.
Maximum String Length
64 characters
Kramer Protocol 3000 Commands
Full details for each command are presented in the Kramer Protocol 3000 document available
for download from
www.kramerav.com .
Command Description
# Protocol handshaking
BUILD-DATE? Read device build date
FACTORY Reset to factory default configuration
HELP List of commands
LOCK-FP Lock the front panel
MACH-NUM Sets the machine number
MODEL? Read device model
NAME Sets the machine (DNS) name
NET-DHCP Set DHCP mode
NET-GATE Set Gateway
NET-IP Set IP address
NET-MAC? Read MAC address
NET-MASK Set subnet mask
PROT-VER? Read device protocol version
PRST-RCL Recall a saved preset list
PRST-STO Store the current connections, volumes and modes
PRST-VID? Get video connections from a saved preset
RESET Reset device
ROUTE Set/get data layer routing
SIGNAL? Get input signal lock status
SIG-TYPE Set/get signal type on input/output
SN? Read device serial number
VERSION? Read device firmware version
VID Set video switch state