![background image](http://html1.mh-extra.com/html/kramer/vs-81hdxl/vs-81hdxl_user-manual_2002344017.webp)
14
VS-81HDxl - Connecting the VS-81HDxl
5.4
Switching Genlocked Video Signals
The genlock feature lets you switch genlocked video signals according to timing of
the GENLOCK reference input.
According to SMPTE RP-168. The sources must be genlocked to the GENLOCK input in order
to switch cleanly.
Connect the GENLOCK cable.
If the HD or SD input signal (the unit detects automatically when SD-SDI inputs
are used) that is connected is one of the following, it is necessary to set it up as
follows:
1080i@60Hz: press and hold INPUT 1 button for 3 seconds. The button
flashes to indicate that the set up was completed
1080i@50Hz or 720p@50Hz: press and hold INPUT 2 button for 3 seconds
The button flashes to indicate that the set up was completed
720p@60Hz: press and hold INPUT 3 button for 3 seconds.
The button flashes to indicate that the set up was completed
NTSC: press and hold INPUT 7 button for 3 seconds.
The button flashes to indicate that the set up was completed
PAL: press and hold INPUT 8 button for 3 seconds.
The button flashes to indicate that the set up was completed
If a change is made to the resolution or refresh rate. The button does not flash if the
new timing is the same as that previously selected.
This feature is available in the devices upgraded to the latest firmware version 1.9 or
higher. Contact your Kramer dealer for details.
When turning the machine ON, the appropriate button will flash to indicate the
latest setup (last setup is saved).
5.5
Operating via Ethernet
You can connect to the
VS-81HDxl
via Ethernet using either of the following
methods:
Directly to the PC using a crossover cable (see
Section
5.5.1
)
Via a network hub, switch, or router, using a straight-through cable (see
Section
5.5.2
)