Kramer Electronics Ltd.
VS-44H2
– Operating VS-44H2 Via Front Panel Buttons
13
2. Press an input button (or
ALL
).
The selected input and 7-segment display LEDs of the selected inputs flash.
3. Press a disconnected output button.
Default EDID is copied to the selected inputs.
Operating via Ethernet
You can connect to
VS-44H2
via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see
Connecting Ethernet Port Directly to PC
).
•
Via a network hub, switch, or router, using a straight-through cable (see
).
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
Connecting Ethernet Port Directly to PC
You can connect the Ethernet port of
VS-44H2
directly to the Ethernet port on your PC using a
crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying
VS-44H2
with the factory configured default IP address.
After connecting
VS-44H2
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.
The Local Area Connection Properties window for the selected network adapter appears
as shown in
