8
VS-21H-IR - Operating the VS-21H-IR 2x1 HDMI Switcher
5
Operating the VS-21H-IR 2x1 HDMI Switcher
This section describes how to operate the
VS-21H-IR
, using the SELECT button.
The
VS-21H-IR
functions in two modes: the PC mode (default) (see
Section
5.1
)
and the DVD mode (see
Section
5.2
).
5.1
Working in the PC Mode
This section describes how to acquire / change the EDID (see
Section
5.1.1
) and
how to reset the default EDID (see
Section
5.1.2
) when working in the PC mode.
Note that if a PC is connected to the input, and the EDID is acquired
while running video on-screen, the video stops running and then either
restarts automatically or needs to be restarted via the graphics card
display definitions, depending on the type of graphics card installed in
the PC.
5.1.1
Acquiring/Changing the EDID
You can work with the default EDID or acquire/change the EDID.
To acquire or change the EDID:
1. Connect the new output display device.
If no output display device is connected to the output, the default EDID is
stored in the non-volatile memory.
2. Connect the power while keeping the SELECT button pressed until the LEDs
start to flash.
3. Release the SELECT button while the IN 1, IN 2 and OUT LEDs flash.
The EDID of both INPUT 1 and 2 is altered and stored in the non-volatile
memory.
When a certain input
—INPUT 1 or INPUT 2—is selected, the EDID information
comes directly from the display. When the input is not selected, the
VS-21H-IR
uses the virtual EDID stored in the non-volatile memory.
i
Summary of Contents for VS-21H-IR
Page 1: ...KRAMER ELECTRONICS LTD USER MANUAL MODEL VS 21H IR 2x1 HDMI Switcher P N 2900 000671 Rev 6...
Page 2: ......
Page 15: ......
