![background image](http://html.mh-extra.com/html/kramer/vs-162v/vs-162v_user-manual_2001306013.webp)
Installing and Operating a Single VS-162V - Overview
9
9
6
Installing and Operating a Single VS-162V - Overview
To install the
VS-162V
, connect the following
1
•
Power cord
to the rear panel, as
required:
•
Video input and output cables
•
Control interface cables between switcher units, or PC (or other
controller), as described in section
9
•
Set the DIP-switches, as described in section
8
•
Set the system variables using the MENU function, as described
in section
11
By default, the
VS-162V
is setup for operation as a single machine.
This means that it is:
•
A 16x16 composite video switcher
•
Switched during the vertical interval of the external reference
In particular, be sure that the DIP-switches are set as shown in
Figure 2
(for
more information, see section
8
):
Figure 2: DIP-Switch Setup on a Single Machine
To operate a single machine, see
Table 2
.
Table 2: Quick Reference Operating Guide for a Single Machine
To perform this command:
Press:
Connect an input with an output
OUT #; IN #
Reset a specific output
OUT #; OFF
Reset all outputs
ALL; OFF
Connect all outputs to a specific input
ALL; IN #
Store a setup
STO; OUT #; TAKE
Recall a setup
RCL; OUT #; TAKE
Lock front panel
MENU; TAKE
Unlock front panel
TAKE; TAKE
Change default setup
Press the Menu button several times until you reach the
appropriate Menu setup command and follow the instructions
1 Switch OFF the power on each device before connecting it to your VS-162V