Kramer Protocol
45
Network settings commands
Set gateway address
NET-GATE
GATEWAY_ADDRESS
NTGT
NET-GATE
GATEWAY_ADDRESS RESULT
Read subnet mask
NET-GATE?
NTGT?
NET-GATE
GATEWAY_ADDRESS
Set DHCP mode
NET-DHCP
DHCP_MODE
NTDH
NET-DHCP
DHCP_MODE RESULT
Read subnet mask
NET-DHCP?
NTDH?
NET-DHCP
DHCP_MODE
DHCP_MODE =
0 – Don't use DHCP (Use IP set by factory or IP set command).
1 – Try to use DHCP, if unavailable use IP as above.
Change protocol ethernet
port
ETH-PORT
PROTOCOL
,
PORT
ETHP
ETH-PORT
PROTOCOL ,PORT RESULT
Read protocol ethernet
port
ETH-PORT?
PROTOCOL
ETHP?
ETH-PORT
PROTOCOL
,
PORT
PROTOCOL
= TCP / UDP (transport layer protocol)
PORT
=
ethernet port to enter protocol 3000 commands.
1-65535 = User defined port
0 - reset port to factory default (50000 for UDP, 5000 for TCP)
Advanced switching commands
Command
Syntax
Response
Set audio follow
video mode
AFV
AFV-MODE
AFV
AFV-MODE RESULT
Note:
This command effect device front-panel mode and AUD\VID command.
Read audio follow
video mode
AFV?
AFV
AFV-MODE
AFV-MODE = Front panel AFV mode
"0" or "afv" to set front panel switching buttons in audio-follow-video state.
"1" or "brk" to set front panel switching buttons in their previous state when audio.
