Kramer VP-773, User Manual

Page: 62 / 80

VP-773 - Technical Specifications 57
57
11.1 Default Communication Parameters
RS-232
Protocol 3000 (Default) Legacy
Baud Rate: 115,200 9,600
Data Bits: 8 8
Stop Bits: 1 1
Parity: None None
Command Format: ASCII ASCII
Example (Set display mode to Picture in Picture): #Y 0,110,1<CR> >Y 0 110 1<CR>
Ethernet
To reset the IP settings to the factory reset values, power cycle the device while holding in the
Ethernet Reset button, located on the rear panel of the unit
IP Address: 192.168.1.39
Subnet mask: 255.255.000.000
Default gateway: 000.000.000.000
TCP Port #: 5000
UDP Port #: 50000
Maximum UDP Ports: 10
Maximum TCP Ports: 4
Full Factory Reset
Front panel buttons Turn power off. Turn power on again while holding the RESET TO
XGA/720p front panel button. The LEDs blink. Full factory reset is
complete once the LEDs cease to blink and react normally
OSD Factory Reset through the Misc menu item
Protocol 3000
Use “Factory” command or #Y 0,770,1<CR>
11.2 Input Resolutions
This section defines the input resolutions for each input
11.2.1 HDMI Input Resolutions
HDMI Input Resolutions
NTSC 1080_I60 640x480_72 1024x768_70 1360x768_60
PAL 1080_P23_976 640x480_75 1024x768_75 1366x768_60
525_P60 1080_P24 640x480_85 1024x768_85 1440x900_60
625_P50 1080_P25 800x600_56 1152x864_75 1400x1050_60
720_P24 1080_P30 800x600_60 1280x800_60 1400x1050_75
720_P25 1080_P50 800x600_72 1280x960_85 1600x900_60
720_P30 1080_P60 800x600_75 1280x768_60 1600x1200_60
720_P50 2K50 800x600_85 1280x1024_60 1680x1050_60
720_P60 2K60 848x480_60 1280x1024_75 1920x1200_60RB
1080_I50 640X480_60 1024x768_60 1280x1024_85