![background image](http://html1.mh-extra.com/html/kramer/vp-725n/vp-725n_user-manual_2002241017.webp)
12
VP-725N - Connecting the VP-725N Presentation Switcher/Scaler
5
Connecting the VP-725N Presentation
Switcher/Scaler
This section describes how to connect the
VP-725N
. In particular, how to connect
the:
•
VP-725N
rear panel (see
Section 5.1
)
•
Interlaced and progressive RGBS and RGsB inputs (see
Section 5.2
)
•
PC (see
Section 5.3
)
•
Ethernet port (see
Section 5.4
)
Using the
VP-725N
you can select any one of the 21 inputs and scale that input to
up to three scaled outputs (at the identical resolution).
5.1
Connecting the VP-725N
To connect the
VP-725N
, connect the following to the rear panel, as the example
in
Figure 3
illustrates:
Always switch off the power to each device before connecting it to your
VP-725N
. After connecting your
VP-725N
, connect its power and then
switch on the power to each device.
1. Connect one or more of the following video sources:
Up to four UXGA graphics sources (for example, computers) to the
15-pin HD input connectors
These connectors also accept interlaced and progressive RGBS and RGsB
signals (see
Section 5.2
)
Up to four composite video sources (for example, DVD players) to the
BNC input connectors
Up to four s-Video sources to the 4-pin input connectors (not illustrated
in
Figure 3
)
Up to four component video (sometimes called YUV, or Y, B-Y, R-Y, or
Y, Pb/Cb, Pr/Cr) sources or four RGB sources to the four sets of 3
BNC connectors, G/Y, B/Pb, and R/Pr.
For example, an HDTV satellite receiver to COMP IN 1 and an RGB camera
connected to COMP IN 4.
i