DIP-Switch Settings
Changes to the DIP-switches only take effect on power-up. After changing a switch, reboot the device. All DIP-switches are set to
Off (up) by default.
#
Feature
Dip-switch Settings
1
Reserved
2
Range mode
On (down)
– HDBaseT Ultra-long range (provides increased range at a reduced bandwidth).
Off (up)
– Normal range (default).
Note that range mode affects the HDBT input only
3
Audio de-embedding
On (down)
– Disable audio de-embedding. Note that the audio output port is muted.
Off (up)
– Enable audio de-embedding to the analog audio output port (default).
4
Force RGB
On (down)
– Force RGB mode.
Off (up)
– Normal mode (default)
For optimum range and performance use the recommended Kramer cables available at
www.kramerav.com/product/VM-218DTxr
Step 5: Connect the power
Connect the power cord to
VM-218DTxr
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate the VM-218DTxr
Web pages:
RS-232 and Ethernet:
RS-232/Ethernet
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format:
ASCII Protocol 3000
Stop Bits:
1
Example (Route input 1 to output 1):
#ROUTE 1,1,1 <cr>
Ethernet Parameters
IP Address:
192.168.1.39
Subnet Mask:
255.255.0.0
Default UDP Port #:
50000
Default Gateway: 192.168.0.1
Full Factory Reset
Front Panel
Buttons:
Front panel buttons: power off the device, press and hold the
RESET button for 3 seconds while powering the device, and
then release.
Protocol 3000:
“#factory” command.
Web Pages:
In the Device Settings page, click Reset.
