#
Feature
Function
12
IN 2 IR on a 3.5 Mini Jack
Connect to an IR emitter/sensor cable for IR link extension via IN 2
HDBT.
13
IN 2 RS-232 (G, Rx, Tx) Terminal Block Connector
Connect to a serial controller for RS-232 link extension via IN 2
HDBT.
14
IN 1 HDMI
™ Connector
Connect to an HDMI source.
15
IN 2 HDBT on RJ-45 Connectors
Connect to an HDBT transmitter (for example,
TP-780Txr
).
16
IR on 3.5 Mini Jacks (for OUT 2 to 9)
Connect to remote IR emitter/sensor cables to IR control the devices
that are connected to the HDBT acceptors.
17
RS-232 OUT (G, Rx, Tx) Terminal Block
Connectors (2 to 9)
Connect to serially control the devices connected to the HDBT
acceptors.
18
OUT 1 HDMI Connector
Connect to the HDMI input of an additional DA or connect to a local
monitor.
19
OUT HDBT RJ-45 Connectors (2 to 9)
Connect to HDBT receivers (for example,
TP-780Rxr
).
20
AUDIO OUT 3.5mm Mini Jack
Connect to an analog audio acceptor.
21
RS-232 CONTROL 3-pin Terminal Block
Connect to the serial controller to control the
VM-218DTxr
.
22
REMOTE 3-pin Terminal Block
For future use.
23
SETUP DIP-switches
Use to set the device behavior.
24
ETHERNET RJ-45 Connector
Connect to LAN for Ethernet extension via IN and OUT HDBT ports
and remote IP control of the
VM-218DTxr
.
25
RESET Button
Press and hold while powering on the device to reset to factory
default parameters.
26
PROG Mini USB Connector
Connect to a PC to perform firmware upgrades.
27
Mains Power Connector, Fuse, and Switch
Connect to the mains supply.
Step 3: Install VM-218DTxr
To rack mount the machine, attach both rack ears
(by removing the screws from each side of the
machine and replacing those screws through the
rack ears) or place the machine on a table.
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VM-218DTxr
. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to the
VM-218DTxr
.
