![background image](http://html1.mh-extra.com/html/kramer/tp-600tr/tp-600tr_user-manual_2000986013.webp)
Kramer Electronics Ltd.
TP-600TRxr
– Connecting the 4K60 HDMI/USB Extender
11
Connecting to TP-600TRxr via RS-232
You can connect to
TP-600TRxr
via an RS-232 connection
using, for example, a PC.
TP-600TRxr
features an RS-232 3-pin terminal block connector to extend RS-232 signals via
TP-600TRxr
transmitter and receiver.
Connect the RS-232 terminal block on the rear panel of
TP-600TRxr
to
a device, as follows:
From the RS-232 9-pin D-sub serial port connect:
•
Pin 2 to the TX pin on the
TP-600TRxr
RS-232 terminal
block
•
Pin 3 to the RX pin on the
TP-600TRxr
RS-232 terminal
block
•
Pin 5 to the G pin on the
TP-600TRxr
RS-232 terminal
block
RS-232 Device
TP-600TRxr
EIA /TIA 568B
PIN Wire Color
1
Orange / White
2
Orange
3
Green / White
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
Setting the DIP-Switches
All changes in DIP-Switches apply immediately, on-the-fly (no need to power cycle the
device), except for DIP-switches 1 and 2.
All DIP-switches are set to OFF (up) by default.
# Feature
DIP-switch Settings
1
Device Operation Mode
OFF (up)
– Receiver mode is active.
ON (down)
– Transmitter mode is active.
2
Active USB Host port
OFF (up)
– Host is active.
ON (down)
– Host is inactive (active on remote paired device).
3
Define IR Pass-through
OFF (up)
– Pass-through the IR signal to or from the IR cable.
ON (down)
– Add IR modulation (38kHz) to the IR output signal (applies only when the IR port is
connected to an IR emitter cable).
4
Programing RS-232
Off (up)
– Normal operation mode is enabled (FW programming RS-232 is inactive).
On (down)
– FW programming RS-232 is active.
13