Setting the DIP Switches
•
All DIP-switches are set to OFF (up) by default except for the
TP-590R
DIP-switch 1 which is set to ON
(down) by default.
•
Any changes to DIP-switches 1 and 4 require that you power cycle the device. Changes to DIP-switch 2
apply immediately.
#
Feature
Dip-switch Settings
1
Active USB Host
OFF (up)
– Host is active.
ON (down)
– Host is not active (
TP-590R
default).
2
Define IR Pass-through OFF (up)
– Pass-through the IR signal to or from the IR cable.
ON (down)
– Add IR modulation (38kHz) to the IR output signal (applies only when the IR port
is connected to an IR emitter cable).
3
N/A
For future use.
4
Programing RS-232
Off (up)
– FW programming RS-232 is inactive (Normal operation mode is enabled).
On (down)
– FW programming RS-232 is active.
Step 5: Connect power
Connect the power cord to
TP-590T
and
TP-590R
plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
