KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the TBUS-9 Table Connection Bus
6
5
Installing the TBUS-9 Table Connection Bus
To install TBUS-9, perform the following steps:
1. Cut an opening in the table (see section 5.1).
2. Adjust the height of the connecting surface (see section 5.2).
3. Install TBUS-9 in the cut-out opening (see section 5.3).
4. Connect the cables (see section 5.4).
5.1
Cutting an Opening in the Table
To cut an opening in the table:
1. Place the included cut-out template on the surface of the table where you
want to install TBUS-9.
2. Attach the template to the table with the included screws.
3. Following the inside edge of the template, cut a hole in the table surface
with a sabre or keyhole saw according to the dimensions shown in Figure 4
(not to scale).
Note: The thickness of the table should be 3 inches or less.
Figure 4: Cutout Dimensions
4. Unscrew and remove the template from the surface of the table and clean
the table surface.
Take care not to damage the table.
If needed, you can download a full-scale template from our Web site
1
.
1 At http://www kramerelectronics com
