![background image](http://html1.mh-extra.com/html/kramer/tbus-9/tbus-9_user-manual_2000753009.webp)
Installing the TBUS-9 Table Connection Bus
7
Kramer Electronics is not responsible for any damage caused to the table
5.2
Adjusting the Height of the Connecting Surface
If needed, you can adjust the connecting surface to one of four possible
heights to accommodate large or bulky cables. By default, the height is set
to the second level from the top. To adjust, perform the following:
1. Remove the eight height adjustment screws (two screws on each side, as
shown in Figure 2), while supporting the surface from underneath with your
fingers.
2. Raise or lower the connecting surface to the required height, insert the
screws, and tighten them in place.
5.3
Installing TBUS-9 in the Cut-Out Opening
To install TBUS-9 in the opening:
1. Remove the protective rubber guard from around the outer rim of the
mounting plate. Beware of the sharp edge!
2. Carefully insert the unit into the prepared opening (see Figure 5).
3. Take the support brackets under the table and place them into the support
bracket grooves on both sides of the unit (see Figure 2).
4. Verify proper alignment of the unit before tightening the mounting screws.
5. Screw both mounting butterfly screws upward until they reach the table
surface (from underneath). Tighten firmly (see Figure 5).
6. Screw the locking butterfly screws downward until tight against the
mounting bracket.
Figure 5: Installing TBUS-9