![background image](http://html1.mh-extra.com/html/kramer/modular-tbus-3xl/modular-tbus-3xl_user-manual_2000780015.webp)
12
TBUS-3xl - Installing the TBUS-3xl
5.5 Connecting the Cables
When replacing blank inserts with connector inserts (for example, VGA, audio,
HDMI and so on):
1. Insert the cables to their appropriate connectors from underneath.
2. Secure the cables to the tie holes on the
TBUS-3xl
.
Do not secure the cables too tightly or too loosely. Leave a small amount of
slack.
After the
TBUS-3xl
is connected to mains power and the proper cables, it is ready for
use.
5.6 Inserting Cables via the 4-cable Pass-through Insert
To insert the cables via the 4-cable pass-through insert (for example, to pass
cables from beneath the table to several laptops) do the following:
1. Remove the four screws attaching the split pass-through bracket.
2. Remove the split grommet(s).
The split grommets are not shown in
Figure 6
3. Insert the cable(s) through the rectangular opening.
4. Open the split grommet slightly and insert the required cables.
5. Place the split bracket around the grommet and position this assembly over
the inner frame.
6. Place the four screws appropriately and tighten the split bracket together
with the grommet and inserted cables to the inner frame.
7. Insert the self-locking ties through the tie holes to secure the cables to the
inside walls of the enclosure.