Kramer Electronics Ltd.
KDS-SW2-EN7
– Using KDS-SW2-EN7 Embedded Web Pages
36
3. For HTTPS server, click
On
to enable HTTPS authentication service (default) or
Off
to
disable HTTPS authentication.
4. When set to On, check one of the following settings:
▪
Internal Certificate
– To use the factory default certificate for authentication.
▪
Server Certificate
– To submit certificate from the server for authentication. To do
so, click
to upload the certificate. enter the private key password (assigned by
the IT administrator) and click
APPLY & REBOOT
.
Figure 22: Security Tab
– Server Certificate
5. Click
APPLY
.
HTTPS is configured.
Defining 802.1x Authentication
To configure security:
1. In the Navigation pane, click
Device Settings
. The General tab in the Device Settings
2. Select
Security
tab. The Security tab appears (see
).
3. For 802.1x authentication, click
ON
to enable 802.1x authentication service. 802.1x
supports authentication based on port and MAC address.
4. When set to ON check one of the following settings:
▪
PEAP-MSCHAP V2
– To use this authentication method, enter a Username (up to
24 alphanumeric characters, including “_” and “-“ characters within the username)
and Password (up to 24 ASCII characters):
Figure 23: Security Tab
– EAP-MSCHAP V2 Authentication
