Technical Specifications
9
7 Technical Specifications
Table 6 includes the technical specifications:
Table 6: Technical Specifications
1
of the FC-4002 Format Converter / TBC
INPUTS:
1 composite video - 1 Vpp / 75 on a BNC connector
1 YC - 1 Vpp/75 (Y), 0.3Vpp/75 on a 4p connector
1 component - Y/R-Y/B-Y (1Vpp/0.7Vpp/0.7Vpp) /75 (or RGB/S) on BNC
connectors
1 SYNC (Genlock): Looped 75 / Hi-Z on BNC connectors
OUTPUTS:
1 composite video on a BNC connector 1 Vpp/75
1 YC video on 2 BNC connectors: Y 1 Vpp/75 , and C 0.3Vpp/75
1 component or RGB/S video on BNC connectors 1Vpp/0.7Vpp/0.7Vpp/75
1 SYNC on a BNC connector
VIDEO STANDARDS:
PAL-B/D/G/H/I/M/N, NTSC-3.58/4.43, SECAM
DIGITAL RESOLUTION:
10 bits
BANDWIDTH (-3dB):
0.5dB to 5MHz, Fully Loaded
DIFF. GAIN:
1%
DIFF. PHASE:
1 Deg.
K-FACTOR:
1%
S/N RATIO:
63dB
LUMA NON-LINEARITY:
1%
CHROMA / LUMA DELAY: 1ns
CONTROLS:
Front-panel and RS-232; SCH phase, SYNC phase, H shift, freeze, panel lock
POWER SOURCE:
100-240VAC, 50/60Hz, 14VA
DIMENSIONS:
19 inch (W), 7 inch (D), 1U (H) rack mountable
WEIGHT:
2.6 kg. (5.7 lbs.) approx.
ACCESSORIES:
Power cord, Null-modem Adapter
8 Communication Protocol
RS-232 communication between the
FC-4002
and the PC is performed using
this protocol (VER-0.1), which uses four bytes of information, and data is at
9600 baud, no parity, 8 data bits and 1 stop bit.
The controller and the machine should be connected via a null-modem
connection, that is, if using a DB-9 port, connect PIN 5 of the PC to PIN 5 of
the machine, cross PINs 2 and 3, that is, connect PIN 2 of the PC to PIN 3 of
the machine, and connect PIN 3 of the PC to PIN 2 of the machine. On the PC
side, short PINs 4 and 6, and short PINs 1, 7 and 8. This protocol
complements Kramer’s “Protocol 2000” (Kramer’s switcher protocol), that is,
the two protocols can co-exist without disturbing one another (according to
Protocol 2000’s definitions, the
FC-4002
would be machine number 24).
1 Specifications are subject to change without notice
