Connecting the FC-26
13
3. Connect IR emitters to the IR Outputs, (for example, two IR emitters for Blu-
ray disk player and multimedia player control, and an IR blaster).
4. If the
FC-26
is not supplied with power by a PoE provider, connect the
device to the power adapter and connect the power adapter to the mains
electricity (not shown in
Figure 6
).
6.1
Connecting via Ethernet
You can connect to the
FC-26
via Ethernet using either of the following methods:
Directly to the PC using a crossover cable (see
Section
6.1.1
)
Via a network hub, switch, or router, using a straight-through cable (see
Section
6.1.2
)
Note
: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.1.1
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
FC-26
directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
FC-26
with the factory configured default IP address.
After connecting the to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and
click
Change settings of this connection
.
The Local Area Connection Properties window for the selected network
adapter appears as shown in
Figure 7
.
i
Summary of Contents for FC-26
Page 1: ...KRAMER ELECTRONICS LTD USER MANUAL MODEL FC 26 Ethernet Controller P N 2900 300463 Rev 1 ...
Page 2: ......
Page 63: ......
