Kramer FC-21ETH, User Manual

Page: 27 / 60

Remote Operation via the Web Pages 23
7 Remote Operation via the Web Pages
The embedded Web pages can be used to remotely operate the FC-21ETH ,
FC-22ETH and FC-24ETH using a Web browser and an Ethernet connection.
Before attempting to connect:

Perform the procedures in Section
‎6.1
.

Ensure that your browser is supported (see Section
‎9
)
Note : The FC-24ETH is used throughout this chapter as an example. The same
principles apply to the FC-21ETH and the FC-22ETH .
7.1 Browsing the FC-24ETH Web Pages
To browse the FC-24ETH Web pages:
1. Open your Internet browser.
2.
Type the device’s IP number (see
Section
‎10
) in the Address bar of your
browser.
The Loading page appears followed shortly by the General Info page shown in
Figure 14 .
The General Info page displays the following:

Model Name

Firmware version

Device serial number

Web page version
At the bottom left hand side of all pages there are Load/Save Configuration buttons.
These allow you to save the current configuration and load any presaved
configurations.