KPS 602150001, Instruction Manual

Page: 44 / 74

44
KPS-PA70 • Digital clamp meter
ENG
4.13 Resistance Test
WARNING
Electric shock hazard. When measuring circuit impedance, determine
that the power supply is disconnected and the capacitor in the circuit
is completely discharged.
• Insert black probe to COM jack, insert red probe to INPUT jack.
• Place measuring range switch to position. At this time, the meter is in the
measurement state.
• Connect the probe to the both ends of resistor or circuit to be tested for
measurement.
• LCD will show readings.
NOTE:
1) When the input end is open, LCD shows “0L” outrange state.
2) When the resistance to be tested>1M, the meter reading will stablilizee after
a few seconds, which is normal for high resistance readings.
4.14 Diode test
• IInsert black probe to COM jack, insert red probe to INPUT jack.
• Measuring switch is placed to position .
• Press “FUNC” key to switch to measuring state.
• Connect the red probe to diode anode and connect the black probe to diode
cathode to make test.
• Read on the LCD.
NOTE:
1) What the meter shows is approximation of diode forward voltage drop.
2) If the probe has reverse connection or the probe is open, the LCD will show
“0L”.
4.15 Circuit Continuity Test
WARNING
When measuring circuit continuity, determine that the power supply is
disconnected and the capacitor in the circuit is completely discharged.