2 1
1. Install legs and pedestal decorating trim.
l
Except model GFN2505 GFP2506
Lay the heater down on its back and install the legs with
care on the bottom panel (as shown in Figure 1). Make
sure the vein side is forwards.
l
Install the pedestal decorating trim (front and side) under
the pedestal with screws.
2. Install the decorating logs.
l
Fasten decorating logs 1
、
2
、
3 onto the correspondent angle iron (Figure 4).
l
Insert the pinhole on the upper part of log 4 into the pin on the left side of log 1. Place the lower part on
the flat roof at the left side of log 3 (Figure 5).
l
Insert the pinhole on the upper side of log 5 into the pin on the right side of log 1. Place the lower part on
the flat roof at the right side of log 3 (Figure 6).
5. Install the heater according to the Installation in the owner
’
s manual.
Figure 1
Figure 2
Figure 3
Figure 5
Figure 4
Figure 6