32
FIREPLACE SET UP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#SLA-60 R.8 March 2022
8.3 Glass Media
WARNING: DO NOT BLOCK PILOT WITH GLASS MEDIA. A BLOCKED
PILOT MAY CAUSE DELAYED IGNITION.
NOTE: Follow instructions below for proper installation of your specific
glass media. Do not substitute materials.
8.3.1 #115 Series Glass Media Installation
1. Remove glass media from its packaging. The glass media may be
cleaned prior to installation. See 8.3.44 below.
2. Install 15 lbs. (6.8 kg) of glass beads onto burner assembly and
pilot shield.
3. Verify glass media is one layer deep across the firebox and does
not block any burner ports. Do not block the pilot assembly.
4. Save any unused media for later use.
8.3.2 #215 Series Glass Media Installation
1. Remove glass media from its packaging. The glass media may be
cleaned prior to installation. See 8.3.4 below.
2. Install 15 lbs. (6.8 kg) of crushed glass onto burner assembly and
pilot shield.
3. Remove 75% of the crushed glass covering the burner ports. Do
not block the pilot assembly.
4. Save any unused media for later use.
8.3.3 #311 Series Glass Media Installation
1. Remove glass media from its packaging. The glass media may be
cleaned prior to installation. See 8.3.4 below.
2. Install 11 lbs. (4.99 kg) of crushed glass onto burner assembly
and pilot shield.
3. Save any unused media for later use.
DO NOT BLOCK
THIS AREA
Figure 8.1, Burner Ports
REMOVE 75% OF CRUSHED GLASS COVERING THIS AREA
Figure 8.2, Pilot Assembly Area
8.3.4 Cleaning Glass Media
As a natural reaction from direct contact to heat and exposure to
flame, glass media may discolor or produce a fine oil residue. Follow
instructions below to clean glass media. Contact your local authorized
dealer for replacement glass media.
•
Remove glass media from firebox using protective gloves.
•
Clean glass media with mild dish soap and water.
•
Drain and rinse the glass media thoroughly. Verify the glass
media is completely dry before placing on media tray.
•
Follow instructions above for your specific glass media
reinstallation. Do not block the pilot assembly with glass media.
