23
9.1 Initialize the Control System for
the First Time
Remove all packaging and combustible material from the
firebox before initializing the control system.
• Set the main ON/OFF rocker switch to OFF position.
• Install 4 AA batteries (included in components packet) in the
battery backup holder with correct polarity.
• Connect the IFC module to an AC power supply.
• Install 3 AAA batteries (included in components packet) in
the remote control battery bay, located at the base of remote
control. Note polarity of the batteries and insert them as
indicated by silkscreen (+/-) on the battery cover or holder.
NOTE: Performing the next step will initiate pilot start-up in
manual mode, where the pilot igniter will spark repeatedly. The
pilot will ignite if gas is supplied to the fireplace.
1. Press the red SW1 button on the IFC module.
2. The control module will BEEP (3) times, and/or illuminate
an amber LED, indicating it is ready to synchronize with the
remote control.
3. Within (5) seconds, push the remote control ON/OFF button.
The IFC module will BEEP (4) times to indicate the remote
control’s command is accepted, and is set to the particular
code of that remote control.
4. Press the remote control ON/OFF button again. The pilot will
shut down indicating the remote has taken over. The system
is now initialized.
5. Set the main ON/OFF rocker switch to ON position to
operate the fireplace with the remote control.
If pilot does not ignite and the red LEDs indicator blinks (2)
times in intervals, contact your dealer. This is a pilot flame
error condition.
LEDs
SWI Button
Figure 9.1, IFC Module
Low battery alarm
Key Lock
Light ON
Room
T
emperature
Set Point
T
emperature/Level/State
Flame ON
Thermostat OFF/
ON/SMA
RT
Fan
T
ransmission
Split Flow
CPI mode
ON/OFF
Key
Thermostat
Key
UP/DOWN
Arrows
Mode
Key
LCD Display
LCD Display
Figure 9.2, Remote Control and Display
Summary of Contents for Chaska-34 LOG
Page 32: ......
