FIREPLACE SETUP
29
8.2 #B41-500 Log Set Installation
CAUTION: Do not place logs directly over burner port holes.
Improper log placement may affect flame appearance and
cause excessive soot to build upon the logs and glass.
•
If converting to LP (propane) gas, complete the conversion
before installing the log set. Follow the conversion
instructions included with the kit.
•
Log numbers are located on the bottom of each log. Refer
to the following instructions and illustrations for proper log
placement.
1.
Position the ember panel in front of the burner.
2.
Align the holes in bottom of base logs (BP1 to BP4) with the
mounting pins on the burner. Push logs down onto pins to
seat.
3.
Align logs BP5 and BP6 with the notches on the base logs.
4.
Align logs BP7 and BP8 as shown in Figure 8.2.
5.
Distribute rockwool embers onto the logs and burner using a
stif bristle brush.
Figure 8.1, Base Logs
Figure 8.2, Installed Log Set