16
Speed positions
You control the speed of the engine with the speed control switch (8) by choosing
the position 1,2 or Pulse (Ice-crush function). The switch does not lock in the Pulse
position. In order to work in the Pulse function, hold the switch in the Pulse position
or turn it into Pulse position repeatedly.
Crushing ice cubes
Add the ice cubes to the jug (not more than 8) and close the glass jug (3) with both
lids (1 and 2). Hold the speed control switch (8) in Pulse position for a few seconds,
then turn it back to 0-position. When the ice cubes lie back at the bottom of the mix-
ing jug, you can turn the speed control switch back in the Pulse position. continue
this process until the ice cubes have been crushed to preference.
04
PE - LD
Suggestion:
Only fill ice cubes in the mixing jug when the engine is switched off.
Use of speed positions
(1) – Low – for easy use with fluids (e.g. drinks, cocktails, milkshakes, etc.)
(2) – High – for more solid ingredients – mixing/pureeing of fluids and foods
(Pulse) – use only for a few seconds – for crushing ice cubes or for mixing foods
(Turbo) – additional Pulse function with higher speed in position (1)
04
PE - LD
Caution:
Never operate the blender longer than one minute without a break.
The blender needs to cool off for 3 minutes before it can be used again. This process
may be repeated 3 times. Afterwards, the blender has to cool down for 15 minutes,
otherwise it may cause damage to the appliance.
Cleaning and care
• Before cleaning, switch off the appliance and disconnect it from the mains (12).
Let the appliance cool down.
• clean the engine block with a damp cloth. Do not let water enter the appliance.
• Do not use any aggressive cleaning agents.
• When cleaning the glass jug (3), always disconnect it from the engine block (7).
Glass jug (3) and lids (1 and 2) may be washed with warm water and dishwashing
detergent or dishwashing liquid.
instruct_24001_blender_KORO_05-12.indd 16
21.04.12 11:25
